The Amphibian Forum
The Amphibian Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Frogs & Toads - (Anura)
 Frog & Toad Health
 adequate heating for tree frogs

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
badmary Posted - 31/05/2010 : 18:17:44
I have two Whites tree frogs and 2 tomato frogs and am struggling to get their housing temperature up to the required temperature. I have a heat mat covering about a third of the floor area and a long fluorescent day light as recommended. However, this is only producing a temperature of between 60 and 70 degrees and I'm concerned that this isn't hot enough. As the advice is not to add a heat lamp what can I do to increase the temperature?

Humidity levels are good.

2   L A T E S T    R E P L I E S    (Newest First)
Kazerella Posted - 09/06/2010 : 11:53:09
I think the insulation Ade hinted on is important too - we usually put polysteyrene or bubble wrap around the sides of the tank during winter to keep the heat in. It usually raises the temp by about 2-5 degrees so works. It just doesn't look very good
Ade Posted - 02/06/2010 : 15:30:22
Yeah, heat mats will only raise the temps up by a small amount above the ambient temperature of the room they are in. The trick to get them warmer is to make sure the room is kept at about 22 degrees Celsius so the mats have less to do. I also have 2 mats on my whites set up, 1 on the side with polystyrene on the outside of it, and 1 on the base, again with polystyrene on it. Placing mats just on the bottom you lose a lot of the heat from them as it doesn't make it through the substrate, but on the plus side it helps keep humidity up, especially if like me you use a 2 layer substrate, with water in the bottom half. By putting one on the side the heat goes directly where it's needed.

When I started out, such a short time ago, I had the exact sames problem as you. Tips on here guided me into the 2 mat method.

Ade

The Amphibian Forum © 2000-08 The Amphibian.co.uk Go To Top Of Page
Snitz Forums 2000